wetzoeker

7.3 — Extent of thickness measurements Keuringsregeling scheepvaart (CAS) bij het Protocol van 1978 bij het Internationaal Verdrag ter voorkoming van verontreiniging door schepen, 1973 (Keuringsregeling scheepvaart (CAS))

Extent of thickness measurements

7.3.1 The thickness measurements shall be recorded using the tables contained in Appendix 2 of Annex 10 of Annex B of the 2011 ESP Code. It is recommended that these records be kept in an electronic medium.

7.3.2 The thickness measurements shall be carried out either prior to or, to the maximum extent possible, concurrently with the close-up survey.

7.3.3 The minimum requirements for thickness measurements for the CAS surveys shall be those set out in the table below:

Table 7.3.3

Thickness Measurements Requirements

1. Within the cargo area: .1 Each deck plate (see note) .2 Three transverse sections .3 Each bottom plate

2. Measurements of structural members subject to close-up survey according to 7.2.2, for general assessment and recording of corrosion pattern

3. Suspect areas

4. Selected wind and water strakes outside the cargo area

5. All wind and water strakes within the cargo area

6. Internal structure in the fore and aft peak tanks

7. All exposed main deck plates outside the cargo area and all exposed first tier superstructure deck plates.

Note:

In conjunction with thickness measurement procedures, in case of concern regarding residual throat thickness of the fillet weld between the deck plate and deck longitudinals or possible detachment of a deck longitudinal member, the attending surveyor may refer to the Guidelines on the assessment of residual fillet weld between deck plating and longitudinals adopted by resolution MEPC.147(54).

7.3.4 Where substantial corrosion is found, the extent of the thickness measurements shall be increased in accordance with Annex 4 of Annex B of the 2011 ESP Code.

7.3.5 In addition, the thickness measurements may be extended as considered necessary by the attending surveyors.

7.3.6 For areas in tanks where coatings are found to be in GOOD condition, the extent of thickness measurements, according to paragraph 7.3.3, may be specially considered by the RO. However, sufficient thickness measurements shall be taken, in all cases, to confirm the actual average condition and the maximum observed diminution of the structure.

7.3.7 The thickness measurement to be taken shall be sufficient to enable the reserve strength calculations in accordance with Annex 12 of Annex B of the 2011 ESP Code.

7.3.8 Transverse sections shall be chosen where the maximum diminutions are expected to occur or are revealed from deck plating thickness measurements. At least one transverse section shall include a ballast tank within 0.5L amidships.

Regeling
Keuringsregeling scheepvaart (CAS) bij het Protocol van 1978 bij het Internationaal Verdrag ter voorkoming van verontreiniging door schepen, 1973 (Keuringsregeling scheepvaart (CAS))
Afkortingen
CAS
Soort
Verdrag
Geldend vanaf
01-10-2014
BWB-id
BWBV0006313
Versie
2014-10-01_0

In de hele regeling · Officiële tekst op wetten.overheid.nl