wetzoeker

Regulation 10 Internationale overeenkomst voor veilige containers (CSC)

REGULATIONS FOR APPROVAL OF EXISTING CONTAINERS AND NEW CONTAINERS NOT APPROVED AT TIME OF MANUFACTURE

If, on or before 6 September 1982, the owner of a new container which was not approved at the time of manufacture presents the following information to an Administration:

(a) date and place of manufacture;

(b) manufacturer's identification number of the container if available;

(c) maximum operating gross mass capability;

(d) evidence to the satisfaction of the Administration that the container was manufactured to a design type which had been tested and found to comply with the technical conditions set out in Annex II;

(e) allowable stacking load for 1.8 g (kg and lbs); and

(f) such other data as required for the Safety Approval Plate;

the Administration, after investigation, may approve the container, notwithstanding the provisions of Chapter II. Where approval is granted, such approval shall be notified to the owner in writing, and this notification shall entitle the owner to affix the Safety Approval Plate after an examination of the container concerned has been carried out in accordance with Regulation 2. The examination of the container concerned and the affixing of the Safety Approval Plate shall be accomplished not later than 1 January 1985.

Regeling
Internationale overeenkomst voor veilige containers (CSC)
Afkortingen
CSC, CSC 1972
Soort
Verdrag
Geldend vanaf
01-07-2014
BWB-id
BWBV0003233
Versie
2014-07-01_0

In de hele regeling · Officiële tekst op wetten.overheid.nl