wetzoeker

8.2 — Objects on strips Besluit toezicht luchtvaart BES

Objects on strips

Within the general area of the strip adjacent to the runway, measures shall be taken to prevent an airplane’s wheel, when sinking into the ground, from striking a hard vertical face. Special problems may arise for runway light fittings or other objects mounted in the strip or at the intersection with a taxiway or another runway. In the case of construction, such as runways or taxiways, where the surface must also be flush with the strip surface, a vertical face can be eliminated by chamfering from the top of the construction to not less than 30 cm below the strip surface level. Other objects, the functions of which do not require them to be at surface level, shall be buried to a depth of not less than 30 cm.

8.3 Grading of a strip for precision approach runways Chapter 3, 3.4.8 recommends that the portion of a strip of an instrument runway within at least 75 m from the centre line shall be graded where the code number is 3 or 4. For a precision approach runway, it may be desirable to adopt a greater width where the code number is 3 or 4. Figure A-3 shows the shape and dimensions of a wider strip that may be considered for such a runway. This strip has been designed using information on aircraft running off runways. The portion to be graded extends to a distance of 105 m from the centre line, except that the distance is gradually reduced to 75 m from the centre line at both ends of the strip, for a length of 150 m from the runway end.

Regeling
Besluit toezicht luchtvaart BES
Soort
AMvB-BES
Geldend vanaf
01-01-2021
BWB-id
BWBR0028721
Versie
2021-01-01_0

In de hele regeling · Officiële tekst op wetten.overheid.nl